LED Remote Controller

Connection and use:
1. in accordance with the connection icon, the two-pin plugs 12V DC power cable connection, + then positive, - then negative.
2. Four-pin LED module connected, V connection module positive (white line), R then red, G take the Green Line, B then the blue line.
3. connected to 12V power supply, LED module start automatically change at this time.
4. Controller has memory function, power failure re-power to maintain power and speed of previous models.
Change mode controller
1, gradient 2, transition 3, Red 4, Green 5, Blue
6, Yellow 7, 8 blue, purple, white 9
Remote control for use
Key 1: LED buttons to accelerate the pace of change 2: LED slow down the pace of change key 3: LED brightness decreases
Key 4: LED brightness enhancement button 5: LED changing pattern of increase in key 6: LED changing pattern of reduced
Note:
Controller must be connected DC (DC) 12V power supply and power supply enough power to drive the load
(modules). Controller allows maximum current 8A, the maximum load current of each channel should not exceed 8A.